Emulsion primer – water base

Protection of concrete sections that are adjacent to the soil is mandatory and unavoidable. Soil contains chemical and sulfate ions, which, if concrete surfaces are not properly protected, can cause destructive factors to penetrate into the structure and damage the concrete section. The best opportunity to protect concrete against chemical and sulfate agents is in the early hours of concrete placement. This is because concrete in its pasty state tends to lose a lot of water and may also be in contact with sections that are water absorbent, and the concrete mixing water may decrease before participating in the hydration process, which will cause surface cracks or in some cases deep cracks. This occurs due to shrinkage and shrinkage and volume loss of the mortar. These cracks are the best way for ions, chemical and sulfate agents to penetrate into the concrete, which will eventually lead to corrosion of the rebar in the rebar network and, over time, serious damage to the structure. To solve this problem and protect fresh concrete from the penetration of destructive environmental factors, as well as insulate the concrete surface to reduce water loss, a water-based emulsion primer product formulated based on modified bitumen and resins is used.

Water-based emulsion primer is a single-component product based on bitumen and special mineral powders and has good adhesion to steel, concrete, brick, asphalt and other construction materials surfaces during application. After drying, this bitumen insulation will be resistant to moisture and water vapor penetration and insulates the surface to a large extent. When applied in two layers, water-based emulsion primer completely insulates and waterproofs the surface, but generally water-based emulsion primer is used as a base layer for applying emulsion insulation.

In general, this bitumen waterproofing is an emulsion-based bitumen primer formulated and produced for use as a primer and sealer coating. Among its features are cost-effectiveness, solvent-free, anti-corrosion, etc. These coatings are designed to protect and waterproof concrete, especially when exposed to aggressive soils or other environmental factors.

This emulsion primer is a type of initial coating that is used before applying the main layers of paint, insulation or other coatings to the surface. This primer is prepared from water emulsions and is used as an initial layer to improve adhesion, smooth the surface and increase the durability and final quality of subsequent coatings.

What is the packaging of bitumen emulsion insulation like?

20 kg bucket

What are the storage conditions for emulsion (bitumen) insulation?

Duration: One year in original packaging.

Conditions: Away from cold and frost, heat and direct and prolonged sunlight.

Best storage temperature: +10 to +30 degrees